Recent content by SigTauMatt

  1. S

    Ecomaster / Enermax Coenus and Triathlor Lucky Draw

    I'd want a *bunch* of T.B. Silence Blues to keep the battle chill.
  2. S

    x16 slot only running in x8

    Just tried another card in the machine and get the same results. Looks like imma have to RMA this mobo. Anyone have any history in dealing with gigabyte?
  3. S

    x16 slot only running in x8

    Ok, so I took the card out once again (cleaned the connectors and slot) and noticed, for the first time, the little switch near the CF connector. It is set to 1 by default (or, pushed away from the connector). I'm wondering if I switched this to the other position if it would make a difference...
  4. S

    x16 slot only running in x8

    shadowman01, this may be the route i'll have to take. I can't try disabling the USB 3.0 controller on my board because my UEFI won't allow it. :-( I'll keep searching for a few days before I take such an action, however. I have a 3-day break coming up soon.
  5. S

    x16 slot only running in x8

    *EDIT* Reading up on another board somewhere about the intel USB 3.0 controller causing similar problems with a fella's GTX card (he hasn't tested an AMD card yet). He disables the controller and his paths open up. I'll give this a shot after I finish packing and update the thread.
  6. S

    x16 slot only running in x8

    Ok guys, I just wrapped up pulling and resetting the card, wiping and reinstalling the drivers, double-checked the UEFI settings, and rtfm. CCC gives me pci-e 2.0 8x. gpu-z and Trixx both give me pci-e 3.0 x16 @ x8. The only thing left is to try the beta BIOS from Gigabyte, unless Sapphire...
  7. S

    x16 slot only running in x8

    Parja, no, I do not. It's the only card installed. scharfshutze009, i've done this. I'll do it again. ;) Praying the mobo isn't faulty. I did notice during a fan reconfiguration that the 6-pin cords were weighing down the end of the card a bit. I hope this didn't damage anything. I'll...
  8. S

    x16 slot only running in x8

    I have a 7870 xt in the top slot of my Gigabyte z77-ds3h. Trixx, gpu-z, and CCC all say my card is running at x8. I've disabled Link State Power Management. Both Cat 13.4 and 13.6 give the same feedback. I don't know what else to do. I know that performance isn't really effected, but the fact...
Back
Top