I have the Kingwin 9225 on my kids' PC, cooling an E4500.
My PC has Xigmatek HDT-S1283, with the bolt through kit on other side of board, cooling an E8500.
The S1283 is the best cooler I have owned so far. It Cools remarkably well for an air cooler, and its quiet.
I finally got my E8500, and I have been running this board for a little for almost 2 weeks.
I kept the stock NB cooler and raised my north bridge voltage to 1.2 volts. While Running IBT, PC Probe II, and a couple of other app's at the same time, my North bridge temperature has never gone over...
The high pitched whine might be a capacitor leaking. When you overclock one of the cap's might get hot, and they can begin to "boil out" their insulation fluid. This can make a hissing noise, or the sound like a whining teapot.
In any case, you probably will want to look over your motherboard...
thx. I just read about stuck sensors on the semi-newer processors. Apparently the temp sensing is more accurate than before, but sometimes the themal sensors won't switch on until the CPU produces some significant heat. Mine switches on any time the CPU goes above 102 F. / 39 C. No big deal...
Thanks Mr. Sparkle. From quickly reading some internet posts, CPU TM function does not prevent overclocking. One poster on another forum actually tested 2-3 CPUs overclocked with TM enabled and disabled, and he found no difference in the ability to overclock. From what I have read, the TM...
Hey thanks for the info. I disabled DRAM static Read Control, and I now I can raise FSB to 416 and it passes IBT.
I set all the options you specified, and I raised FSB to 420. But at 4 GHz Intel burn test fails. The last 4 Mhz that I need on the FSB is being stubborn.
I will try slowing...
I recently bought the 8500 and P5 Pro, and I am trying to get the 8500 overclocked to 4 Ghz. Whenever I set the Front Side bus past 415, the overclock fails Linpack/Intel Burn Test. I am running Windows XP 32 bit w/ 4x1 GB of RAM, system sees 3 GB.
This is what I have set in BIOS:
CPU Ratio...
I almost bought the Thermalright HR-05-SLI, its an awesome cooler. I'm at my budget for this build now, but the HR-05 is what I would get if I were to replace the the existing north bridge cooler.
Redkd, you are probably right, I may be able to get 4.2 + Ghz on the E8500. Hopefully it will...
Adding the Zalman cooler to the soutbridge chip was probably overkill, but I don't mind. Hardware Canucks had their south bridge temp at 47 C after running OCCT for 2 hours with the FSB set to 400. Theirs was in a closed case w/ no side fan.
I had ordered the Zalman cooler thinking of adding...
Hardware Canucks has a pretty good review of this board, P5Q Pro. They noticed that the south bridge runs hothotter than the north bridge, while overclocking and under a load.
http://www.hardwarecanucks.com/forum/hardware-canucks-reviews/8783-asus-p5q-pro-p45-motherboard-review-15.html...
This prob. won't help you, but here is a copy of bios Options for P5Q Pro. This was written by KetXXX and posted at TechPowerup forums, but I can't find it there any more.
http://matt.fomich.googlepages.com/P5Q-Pro-BIOS-options-explanation.rtf