Thanks man, and thanks to all on the forum for the tips and ideas ;)
@pman065 - the front intake is a BitFenix Spectre 200mm, the top mounted fans are 140mm Spectres, fans on the rad (altho you can only see one - i have one mounted on the outside) are Scythe GT's, hope that answers your...
out of interest, is it pos to remove the front I/O panel to disconnect leads that one does not need, for example the USB3's and Firewire, this would make hiding cables a little easier.
The GT's are awesome even at 1300rpm they are more then good enough is a push pull config to cool any rad, with the increase is life span and how dam quite they are it is win win, if anyone from Scythe is reading, please make 140mm and 200mm GT's
.......must take some pics.....
your PC will shut down before the CPU melts, trust me on that, I had a q6600 running at 98 degrees while running a Prime95 uber test, all the happened was the PC shut down and I let it cool down, and rebooted fine.
going to sound dumb, but have you tried updating drivers for the graphics card ...
I also wish Scythe would step up their game and make 140mm and 200mm GT's, i am also using the BitFenix Spectre fans in my 650D, they are very good fans and really not very noisy at all, atm i have the 200mm as an intake and 2 140mm's as outtakes on the case roof, the stock fans where to noisy...
thanx guys, and that picture really help, the reson i go for a 1000w psu, is that it dont have to work so hard to power everything = less heat, and my old hyper 580w was on it last legs after 3 years of pain ;) once my case comes ill sort out a project log, thanx again
been thinking about getting one of these little beasts since page 155 lol, anyone able to tell me tho if this psu will fit and not bash the motherboard and what not, http://www.ebuyer.com/product/190749 it is about 8 inches long (the PSU that is....) thanx folks and love the work you guys have...