Recent content by redleif

while looking at the photos it seemed that the card had a very slight tilt to it so I took it out and shaved down the bottom of the PCI card slot divider on the case. Popped the card back in and low and behold... Now it works! :D Thanks for everyone's help/advice it finally led me to the...

from this angle it kind of looks like it could be seated further but not by much. I'll see if I can remove the plate and get it seated closer to the board.

No dice. The card is not recognized as being installed by the O/S so it just errors out.

Plugged the DVI into port (labeled 1) on the bottom each time and once the monitor stays blank I switch it to port 2 to verify nothing is happening. I've tested the board with an old GT 240 that works great in one of my old shuttles and it still wont display anything... :( I make sure it's...

Tried this without any luck just a blank screen until I swapped the DVI cable back to the onboard... this is frustrating :mad:

Hi guys I'm completely stumped on this issue that I'm running into with my SZ68R5 and I was hoping someone out there might have run into a similar issue with their box. my specs: Intel i5-3570k 16GB GSkill DDR3-1600 Crucial m4 128GB x 2 (Raid 0) Windows 7 64 Asetek 545LC Water...