Recent content by psklenar

Medyaker, Not sure about Cornflake, but my monitor was repaired and is working perfectly. I was lucky, mine was handled under warranty, but it still cost me $80.66 to ship it from CT to TX what with insurance and all. I can't find the receipt that came back with the display, but it was...

Mine's going to be on the way to TX this evening. <sigh> They think one or more of the electronics boards is going bad. 7 to 10 business days. <whimper> Oh well. The guy DID say they should just swap the electronics as needed and I should get back my original panel ... sure hope so ... I...

Interesting. Yesterday and today I saw something similar, albeit w/horizontal lines as opposed to your vertical ones, when I turned on the display for the first time of the day. I had to cycle it on and off a dozen or so times to get a clean screen, but once I did ... it's working like a champ...

My E8400 Core 0 is stuck at 36C (RealTemp)/46C (CoreTemp), but Core 1 ranges from 32C idle to 48C load per RealTemp (or 42C/58C per CoreTemp). The RealTemp sensor test indicates Core 0 sensor is stuck. Is a "stuck" sensor an indication of likely other problems? Or as long as things like a 12...

:) I'm planning on putting a mid-speed Scythe fan on a Ninja for the CPU cooling, so I'm hoping for somewhat quiet. <fingers crossed> Thanks for the feed back! p

I'm very curious as to how loud this card's cooling set up is. I'm just about to build a new system (to replace a 5yo SFF) and am looking at this card. I like the fact that it is a double slot card so that it's exhausting much of it's heat outside the case instead of further raising the air...

UPS Ground (1-5 days) was least expensive to Connecticut for $11.11 pat----

Since I see questions about this sink fitting in a couple of cases ... does anyone know if this will fit in an Antec Sonata III case? Thanks, pat----

Kyle & Ed, Thank you for the chance for one of these processors. I've been spec'ing out a new system I want to build over the past month or two and now that I'm ready to pull the trigger ... no processors to be found. It's always something. :) Again, thank you for the chance! pat----

In the process of spec'ing out a new system I will start building at the end of the month ... this would be perfect! Thanks for the chance! pat----