I have the AOC-SAT2-MV8, my only issue with it is it doesnt seem to Pass though the SMART Status, but I have used it with 2TB Drives with no issues for a single stream, but not saturating Gigabit LAN.
Danny, do you know if the AOC-SASLP-MV8 passes through SMART Status?
Thanks for your response mikesm.
As I'm in an apartment, I can't move it to a garage unfortunately! I was considering getting a Rack setup in the office, but wouldn't be able to vent it outside, I wonder if I would hear any noticeable difference if I setup a rack with doors and it's own fan...
Sorry to revive a 9 month old thread, it doesn't seem like there were any conclusions posted here on the best way to move WHS on Dedicated hardware to a WHS VM under Server 2008 with Hyper-V? Could anyone kindly link me to an updated thread or tutorial if one exists.
I have the Norco 4020 ordered in November 2008, I'm guessing the 120mm fan bracket from Norco won't work for me, as it says 4020 (new version)?
Previously I didn't spend much time in the Room the 4020 was in, but now I'm in there more and I'm looking to reduce the noise. The case is...
Thanks again for your response. I do have a spare disk, if I install Server 2008 R2 to that disk and just load it up without pulling the existing drives, will it just pick up all the drives with the data scattered? I'm definitely ok with that, what I'm really trying to avoid is having to...
Thank you kindly for your response nitrobass, I should have been a little clearer.
I wasn't thinking of an inplace upgrade by installing Windows Server 2008 R2 on top of WHS, but I was hoping I could install it on the same Machine (Temporarily dual booting). I don't use the backup or...
I've been trying to find a guide to upgrade a WHS V1 Box to Windows Server 2008 R2 (NOT WHS 2) on the same machine without any success.
I have 20 Drives under WHS and I'm wondering how I can migrate away from it.
Any direction would be appreciated.
Looking at 3 27" Dell U2711 Monitors however they are 25.46" Wide, does anyone know if this can be modified a little bit to accommodate the 0.92" overage from the recommended 50" Max Width for the center and side monitor?
I'm looking to setup a new home office with 2 Stations and 6 monitors.
Ideally Station #1 would be able to use all 6 Monitors, but if Station #1 and #2 were in use at the same time, 3 of the 6 monitors could slide over for the second person.
I've done the Eyefinity research for...