Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.
This technology will increase FPS 10% at the cost of a good 50% extra processing lag, look at the example charts for when those frames actually get sent to the display. It's a terrible tradeoff.
Ideally I'd wait for a 200% improvement on benchmarks for under $500.
My last upgrade was a 4850 to a 7970, and I think I'm going to be waiting for another generation or two to make the next jump.
I've been following a rule where I upgrade if I get 4x the performance for $500 or less, which is probably less on the [H] side of things, but still allows for some wiggle room. (I'm telling myself this so I don't switch tabs to amazon and order a 980 :p)
My GPU History:
6800 GT ~ 2006
HD 4850...
In most 3d applications, you're not going to have a steady beat of fps. Heavy action cause it to dip, while staring at a wall could cause it to jump into the 200s. Increasing your average fps above 60 won't cause you to display more frames on a 60hz monitor, but it will reduce the amount of time...
I don't see anything odd about these results. If your average without vsync is just under 60, you're going to see a lot of chop as it swaps between 30 and 60 fps when you turn vsync on.
Run some numbers with SLI disabled to see if frame pacing is a compounding factor.
This isn't complicated.
1. Mantle Reduces Draw call overhead, this means we can make more calls at the same CPU cost.
2. At the same time, developers have been employing tricks to display more objects without performing a draw call for each one
There is no good reason the optimizations from 2...
Look, it's been 4 years. That's practically forever in tech. The fact we're even comparing the Deneb core with Kaveri should be recognized as the sham it is.
With any luck we'll see monitors driven by two display port connectors to reach 120hz, but that won't be cheap in terms of monitor or the hardware required to actually reach that refresh rate.
Saying most people don't care about the high end is an understatement. Most people don't care about computer hardware at all. They're making purchases based entirely on what that high schooler on the Best Buy floor recommends. Having the top-end card does not matter to this market segment. Ask...
Find an overclocking guide for the 1055T, since you're locked on the multiplier you will have to lower your ram's clock ratio and raise the FSB to compensate. This brings your motherboard components into play as well, so it is not going to be a smooth ride.