• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

Recent content by kl948

  1. K

    Antec P180 owners .. Please measure this for me

    I need to know how many inches of clearance there is between the top fan and the rear exhaust fan. Vertical distance, not at an angle. I would like to mount a 120mm radiator inside the case, but I'm afraid that the hoses won't have enough clearance due to the top fan. I tried Vantec...
  2. K

    AN8 Ultra owners, do you have heat probs?

    Thanks for the responses guys. :) A few more questions if you don't mind. Since I will also be water cooling, and I'll need to add a fan to cool the mofset anyway, then why not just get the Abit KN8 Ultra instead? I will not be overclocking, so if the AN8 Ultra has more tweak options in...
  3. K

    AN8 Ultra owners, do you have heat probs?

    I was all set to get this board until I read this review. http://www.hardocp.com/article.html?art=ODAxLDc= A few quotes "The chipset and the entire heat pipe as well as the OTES cooler were observed to get extremely hot under standard operating conditions " "there is no doubt that the...
  4. K

    P180 owners .. I need some measurements

    O-P-M, By motherboard tray, I mean the base for the motherboard. The P180 does not have a removable motherboard tray.
  5. K

    P180 owners .. I need some measurements

    One more question ... The specs page for the P180 says the motherboard tray is 12 (W)x9.6(L). Is the 12 inches measured between the top and bottom motherboard stand-offs or from the top edge of the chamber to the bottom edge?
  6. K

    P180 owners .. I need some measurements

    I need some measurements before I purchase this case. I was going to mount a radiator inside on the rear exhaust fan, but I'm not sure if there is enough room for the hoses because the top mounted fan is so close. What I need to know is, how many vertical inches are there between the top...
  7. K

    Question about Koolance PC3-420 series cases.

    Also, how loud are those Koolance cases?
  8. K

    Question about Koolance PC3-420 series cases.

    Are the fans on top of the case that cool the radiator blowing air in or sucking air out? How much coolant does the rez hold? Compared to the Swiftech H20-120 kits, how do the Koolance systems rate?
  9. K

    Swiftech H20-120 kit questions

    I haven't purchased all the parts yet, but if I had to buy it today, I would get an Athlon 64 3500+ (venice core) and a Radeon x800.
  10. K

    Swiftech H20-120 kit questions

    http://www.swiftnets.com/products/h20-120-R3a-0.asp Does anyone know what the maximum heat load is for this kit? On the link above, there is a performance data chart, but they only used a 100 watt heatsource for the test. Its got to be able to handle more than 100 watts doesn't it? Do...
See more
Back
Top