Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.
Well I just opened up my U2415 Rev A01 today here in Canada and I can say that I'm quite happy with what I have seen so far. The IPS glow is present but expected. The uniformity is quite strong across the panel, except for maybe a little extra glow along the top edge near the right. But it's...
Has anyone in Canada received the U2415 Rev A01 or higher from Dell?
Considering the history of other Dell monitors, I've been waiting for anything other than A00 before pulling the trigger on this one.
This is a nice evolutionary step up from the U2410. I don't think I will buy it yet for 3 reasons:
1. The panel uniformity feature is pretty useless because it locks the brightness at 50%. (This limitation does not exist on the U2913!)
2. Their hardware calibration is locked to 1 specific...
Never mind, the problem was that the FW updater detected my USB Card Reader, and it started complaining when it coudn't find partition tables in all of the various empty card-reading slots.
Update complete!
Hello all,
I was trying to execute the Plextor M5 Pro firmware update, but I got the "Error reading partition table" message when attempting to boot the update CD-Rw.
The boot did continue after this, but I aborted at the final confirmation because I do not know the source of this error. Has...
I have the P8Z77-V Pro.
Has anyone noticed that when you install the 802.11 WiFi add-on into the motherboard, that it does not fit very well with the I/O shield? The I/O shield does have an opening for the antenna connector, but the the body of the 802.11 add-on is virtually flush with the edge...
Here are the benchmarks for my PX-256M5P on P8Z77-V PRO.
With write-caching:
Uploaded with ImageShack.us
Without write-caching:
Uploaded with ImageShack.us
Thanks for your insight.
The leads on the capacitor itself are not broken. The whole cap, leads and all, were knocked right out of the PCB. When re-inserted, the leads protrude about 1.5mm below the bottom side of the PCB.
Can you recommend any particular type of tips needed on the soldering iron?
I am a fool.
I was installing my Xonar into my new machine, and I screwed up. I ended up knocking a capacitor right off the sound card. This one capacitor pops right back into place, but I think it should be re-soldered back in.
Do you think this is too ambitious or risky a project? I do...
I am going to have to disqualify the Gigabyte GA-Z77X-UD3H because it uses the Atheros AR8151 chip for Ethernet. Sometimes I do Linux work and it seems this chip has spotty support. Seems to be pretty good value otherwise though.
I might go with the MSI Z77A-GD55, though the low number of rear...
Thanks for your comments...
Point well taken about the motherboard. I liked the lack of PCI, lots of USB ports and in-built WiFi adapter on the P8Z77-V Deluxe. I suppose those needs could also be met by external hubs and an external adapter if necessary. I'll have to think this one over. (WiFi...
1) Question answered in OP. (No serious OCs here.)
2) Within 3 months
3) Within 1 month
4)
RAID = don't care
Multi-video cards = don't care
Firewire = desirable but can live without it
USB 3 = essential
SATA III = essential
eSATA = desirable but can live without it
onboad video = don't care...
Budget $1500-1800 before sales tax
Intended Purposes for Machine:
- Programming work with lots of compiling, virtual machines, simulations, etc
- Moderate gaming like Assassins Creed series, DOTA, etc
- Photoshop, video editing and other graphics usage
- General internet and office type usage
-...