• Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
    Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.

Recent content by joking

  1. J

    Who else is waiting for a DFI Infinity 965-s?

    From the look on the picture @ newegg, look likes the tuniq tower will not fit on this board because nb hs may be in the way of the hs fan. May have to turn the tuniq blowing the air to the top but not sure if it still fit.
  2. J

    DS3 North Bridge - Fan Suggestions

    Here is my experience with tuniq tower, ds3. Turnning the tuniq so it blow the air to the top, I have more space to glue a 50 mm fan on top of the NB hs. But then, the rams get kinda hot and the load temp around 64C when running orthos. Turning the tuniq so it blow the air out to the rear...
  3. J

    DS3 Rev 3.3

    My work but then the sound come out on both speakers and the headphones :D
  4. J

    DS3 North Bridge - Fan Suggestions

    For me I stopped by a computer store, get a use 50mm fan for $1.50 then hot glue it. That will do the job.
  5. J

    DS3 rev3.3: Is my vcore too high for 400mhz?

    Ok, I've set the base line at 276 fsb and vcore 1.35 then increase the fsb 5mhz each. So far with each increase in the fsb (5mhz) I have to increase the vcore 1 notch from 1.35 to get it stable. Right now I testing at 386 fsb with 1.3625 vcore. Here is the image Load
  6. J

    DS3 rev3.3: Is my vcore too high for 400mhz?

    unclewebb, Yes I have tried increase vdimm to 2.1v but still not improve anything. My rams is rated at 4-4-4-12 (1.9v-2.1v). I haven't tried 2.2v thought. I have tried to relax the timing with 5-5-5-15 but it gives me BOSD in vista 32 bit but 4-4-4-12 is stable :confused: Yes I have the new...
  7. J

    DS3 rev3.3: Is my vcore too high for 400mhz?

    Thanks Bill, I'm also suspected that my cpu is not a very good oc at lower vcore like you said, but once I got it run orthos stable more than 2 hours then it solid rock. At first I thought I didn't seat the HS correctly so I took every out, clean the old AC5 reapply it, reseat HS but still no...
  8. J

    DS3 rev3.3: Is my vcore too high for 400mhz?

    Here is my set up: DS3 rev 3.3 bios F10 E6300 @ 2.8ghz , vcore 1.4 in bios Tuniq tower 120 + AC5 OCZ plat rev2 ddr2 6400 4-4-4-15 @ 2v Evga 7600gt With vcore 1.4v set in bios I can run orthos stable 12+ hours. Any set lower than 1.4v will reboot after run orthos over an hour. Under load...
See more
Back
Top