Recent content by jacob31

  1. J

    Wasabi Mango UHD400 40" 4k Display

    1. Mine is nowhere near that bad (that is really bad). I'll take a picture of mine tonight and post it. 2. Same as 1. 3. Mine has the same issue (as do other people's). I had the same thought about ground loops, but it made no improvement on mine. My entire setup is on a SurgeX SMP power...
  2. J

    Wasabi Mango UHD400 40" 4k Display

    OK, the verdict is in. It got hotter after 2 hours on brightness 100 (compared to brightness 25), but I could still comfortably keep my finger on the logo on the bezel. Here's the thermal image:
  3. J

    Wasabi Mango UHD400 40" 4k Display

    I'll set it to 100 later tonight and repeat my test. My ambient temp is ~75F. My settings are: Contrast: 70 Saturation: 60 Hue: 50 Gamma: 2.0 Aspect Ratio: Full DCR: Off Color Bypass: Off Picture Bypass: Off Noise Reduction: Off Super Resolution: Off Color Temperature: 6500k Red/green/blue: all...
  4. J

    Wasabi Mango UHD400 40" 4k Display

    Here's a thermal image of mine taken after using it for email/web browsing for ~2 hours. It clearly gets hot near the bottom bezel (especially on the screen in the few inches above the bezel), but the hottest point on mine is only 88F after 2 hours of use, nowhere near too hot to keep my...
  5. J

    Wasabi Mango UHD400 40" 4k Display

    I had 2 far apart dead pixels in the lower left on my pixel perfect model, which I accepted a partial refund of $160 for. They don't bug me because they're far enough apart and not centered. Unless I'm missing something here, isn't it 8.3 million? 3840*2160 = 8,294,400.
  6. J

    Wasabi Mango UHD400 40" 4k Display

    I have the exact same band problem on mine. I think the firmware update made it better, but I might just be going crazy. It's definitely still there, but I think the bars are less offensive. My entire setup is on a SurgeX SMP power conditioner, so I think I can safely rule out power line noise...
Back
Top