Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.
Want to upgrade my system to play BioShock on a 30" at full Direct X 10 resolution.
I assume as far as 30" monitors goes DELL is the one to get
As for video cards I currently have a 7800GT and wanted something single PCI-E that would power a 30" monitor and run BioShock at 2560x1600 with...
I read that CoolIT makes GPU coolers for the Freezone but the only thing I saw on their site was a Quad SLI cooling model. Does anyone know if they make an SLI GPU cooling model?
Thank you
I have the BFG 7800GT in a Shuttle XPC and while the XPC is super quiet the card is loud. Is their a passive heatsink\cooler I can replace for the loud 7800 fan and still have room inside my 1 PCI-E shuttle?
Yes thank you, I actually in between posts found and installed 100.59 which just came out...still no luck. I wonder if it is my Shuttle ST20G5...none of the chipset drivers for this box have been updated since 2005...however the Shuttle does work fine without the card just using it's own onboard...
I did a fresh install of Vista in my Shuttle ST20G5 and although the driver installed succesfully I get only 4 colors because it says "error code 12 not enough resources"
Device manager shows no other devices conflicting in the IRQ settings...
The problem is really frustratiing.
Will cases like the SG02 and the newer Silverstone cases be coming out before September end? I wonder now that we are in mid Sept if they have updated dates.
I have access to a laser cutter and willing to do any cuts needed to properly mount a 2x120 Rad if possible ...
Not sure if that would help, I would rather use this case over the V1200 becuase I like the covered door..
Thank you
Thanks. I am looking at laser precision cutting site now. Did you put your layout in dxf format like they request? I assume that is some type of CAD format. I have a jpeg but not a dxf. Any cheap programs out there that have a low learning curve where I can put it into that format?
Thank you