Recent content by Frustrated

A while ago i got the guts of an alphasmart 3000. For the past few days ive been trying to get this thing hooked up to show temps, etc. However, im have some difficulty finding a program that will transfer data TO the device. I looked it up, and it said that you can *purchase* a program(get...

Well, i got what im SUPPOSED to be doing now, however, im still stumped as of which wires on the parallel port wire should be going to my lcd?

could someone that knows what there doing either explain it to me, or send me an im?

thats odd, because on the pin assignment sheet, it says D0 is pin 8 (http://dataimagelcd.com/product/cm/doc/cm400400.htm)

could someone talk to me through aim? aim= magic Tart Kart

no, i want to make sure there is power going through the lcd.

is it number 1 or 2 that are the numbers on the paralelle port.

again, is there a way to make sure that there is power going through it?

btw: its a fujifilm a303 3.2 mega pixels about $100 guess ive just learned to use it.

okay, so i took a look at your webpage, and got this: PIN# SIGNAL 1 +5 3 +Data 2 -Data 4 GND i know that i use pin 1 for powr, and 4 for ground, and what do the other two do? also, on my data sheet (...

now that i have the data cables plugged in, i need to do the power. How am i do power this? Im a little bit confused as of how i use a usb to power it...explain? can i use this wire [below] ? if yes, how?

thanks guys, almost done. Pics wen done. :) :) :p

i was looking through some other lcd mod how to's. Could i use a printer cable to do all of this?

are there any ideas as of HOW im going to connect this with my pc? Im a fairly new to all of this.

Thank you VERY much.