Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.
Can you explain what a recap is and what is all involved? I have an FW900 I bought back in 2005, and recently when I go above 1920x1200 @ 60Hz, the picture gets unstable and will turn off, accompanied by an electrical burn smell. Runs fine at 1920x1200 @60Hz, but as soon as I increase the...
Thanks for the help!
Also, in your situation was the burning smell a product of using higher scan rates, and did the image start to become unstable prior to the burning smell?
Excellent info! So in your situation was the burning smell a product of using higher scan rates, and did the image start to become unstable prior to the burning smell?
I think I'll try finding the bad transistor by sniffing it out as you did, but I'm a little worried about opening the monitor...
Update...
My FW900 has been working great at 1920x1200 @60 Hz. BUT when I increase the resolution past 1920x1200 or increase the refresh rate over 60 Hz, the image starts getting unstable again, and if left too long the smell of electrical burn is present.
Any thoughts on what is happening?
Me too. I would not have removed it either but when moving a few years back a small scratch was put on the film (it was previously in perfect condition). Looking back now, I probably should not have removed the film over such a small scratch but I haven't noticed really any negative results from...
And this exactly what I'm talking about. I wasn't supporting any seller and just giving my opinion and experience on having the AR on vs removed. I wasn't combative in the least bit until you oddly jumped my shit over it as if I had just slighted one of your family members. Anyone can go back...
I couldn't agree with you more! I voiced the same opinion and got a lot of pushback for whatever reason.
What are your thoughts on cooling the FW900, to prolong its life? I was thinking about adding some exhaust fans to the outside.
Pretty simple. Just 4 screws (2 top and 2 bottom) that screw the back into the bezel, and then the entire shell slides off from the back. There are also a few clamps/claws on the top and sides of where the bezel attaches to the shell that will need to be popped to release the shell from the...
So I did a little research on CRT sparkgaps, and if I understand it correctly, a sparkgap is a protective devices intended to breakdown and divert excessive voltage away from the CRT. This is rarely due to a defective sparkgap or gas discharge tube but rather is a safety mechanism like a fuse...
Lots of great info! I live in Utah, so humidity was not a factor but the temperature was kind of high with the heater going in the room and the FW900 putting off a crap ton of heat after being on for 6 hours straight.
The spark gap would seem to be what caused the oxidated odor. When you say...
Can frequently switching between multiple resolutions on the FW900 cause it to fail (harder on the monitor)? I've recently "upgraded" from an HDFuryX3 to a Startech DP2VGAHD20 adapter to use with my FW900. Before, with the HDFury adapter, I was limited to just 1920x1200 @ 60 Hz resolution. With...
Don't misunderstand me, they are great adapters. I own the original HDFury and the HDFury X3. But for $200 (for the X3), that is a crazy amount compared to the Startech adapter, which offers almost double the pixel clock frequency for $30.