thanks much!
i will be using either/or zero assumption data recovery or getdataback for the raid reconstruction/recovery. both appeared to work well up until the bad drive crashed about midway through recovery
I'll let everyone know how it goes and if I have any success
awesome, thanks so much guys
just would like to ask, I'm planning on cloning the 500gb drive to a 750gb drive
will I have any problems with reading data from the raid array for data recovery since the target drive is larger than the source drive? Or any special command line parameters I...
^^ thanks much...i've heard of it...so um, I'm going to have to install linux, I assume hahah
not familiar with installing it much at all...but I'll give it a shot, thanks!
One of the two drives in my raid 0 array took a dump, and all data recovery programs in windows indicate a large block of clustered bad sectors about 50 percent into the recovery process and then bluescreen with a 'machine check exception' message.
I've run a spinrite level 2 scan on the...
Hello all,
I'll try to make this as brief as possible to save you all from eye fatigue. I had (2) 500gb Maxtor 7200.11 drives (yes, basically rebadged Seagate drives with the firmware problem) running in Raid 0 config for about 3 months (yes, I know, Raid 0, dumb). Long story short, the...