Recent content by Eagle_Eye

As you know release date of windows 7 is october 22nd. I contacted Dell my PC / Laptop vendor. All i wanted to know was how mutch the upgrade would cost me.. for windows 7 ultimate. We all know that big compagnies will be expecting a good amount of revenue that day or sooner with...

i would opt for for samsung synchmaster 1100df <-- is model i have 2048x1536@75hz 21" 20 inch viewable i have this myself and luvin every minut of it.

z-5300 = 180watts z-5300e = 280 watts actually don't quote me on this yet, was looking at diffrent sites, and may not have propper info...

raid +1 it makes an exact duplicate on 2nd drive if drive 1 fails. as well having another computer on network to copy all sensative files to. Or norton ghost.

cpu idle at 30 degrees celcius here at idle. but mine is venice core and not oc'eed. brought mine up to 48 at load. best way i used to test load. by going to geissworks, getting dremples. 100% cpu usage guarenteed. watch cpu temps go up.

Personnaly i would go back to the store with the board and see if they could rma it for a new one... Especially if purchase is less then 30 days.. Could have been week defective plastic that may have broke off.

heat is bad for drives the coller they can run the longuer they will last.. yet you cannot expect HDD to last for ever. i myslef use ultimate HD Coolers with a little bit of cpu past between heatsynch and alluminum top side of drive. so far soo good with my setup.. lookup on...

x2 would be yer better bet bud.. happy shoppin

1st off no ocing? well i would go with MSI, but asus has some nice gidgits... i myself was in same predicament, and i opted for the dfi nf4 sli dr got venice 3200+ due to memory architecturer 4x512 better then 2x1gig 1st off only 1 channel will be used going 2x 1gig high...

Just checking to see how many of ya have probs un-installing NAM? Even re-installing o/s on top still no go.. Even disabeling on board nics and instaling a pci nic still no internet access, so i'm stuck using access @ werk ugh.. any ideas?

have you tried to find the file content.gcf over the net and possibly save it to you drive put it on a cd and the re-try it? I've by passed a few install's and felt like i wasted a few cd's doing it this way lol.. gl, hope steam can help ya!

is there jumper settings on those drives? not used to pata/sata cause i don't have them but yet i have seen this many times being either a jumper setting or possibly just a bad data cable... have you tried replacing the cable?

can you run tracert www.ati.com from a dos prompt while connected?

That is the exact model i have been eye bawlin for a while cheaper then viewsonic, yet perfect for pixel surgery he he he if you get this i'm sure you're going to luv it! i can't wait to get mine!