Recent content by duceduc

Ok. I am back trying this once again. Followed the steps in the first post. The only thing I didn't change was the CPU C3 & CPU C6. These have to be disabled or I am unable to boot through the Windows logo. The issue I am having is that all cores are registering at 4.5MHz even though I have set...

@hardluck I finally found out there was an issue with the firmware 2104 I was in. I have reset cmos and reinstall the same firmware. I am able to boot into Windows one time and when I reboot, I cannot. It get stuck in Windows logo with the hard drive light led and somethings it doesn't. I am...

I figured out my issue where I input any voltage in bios and it won't take affect when test in Windows. It was my bios. I reset the cmos and now it's working as it should be.

To add to what I've mentioned above, I think there is something wrong with my current bios firmware. I may have been a bad flash or incomplete. Looking at the ss below, the me version is missing and my ram memory freq is not displaying. I would hate to have to re-flash the mb. The last time I...

To add to what I've mentioned above, I think there is something wrong with my current bios firmware. I may have been a bad flash or incomplete. Looking at the ss below, the me version is missing and my ram memory freq is not displaying. I would hate to have to re-flash the mb. The last time I...

I am a bit confuse now. Looking at the last screenshot cpu core voltage of 1.280. Is this suppose to be the same voltage I input in bios under cpu voltage? I have input a voltage of 1.250 - 1.360 and the cpu core voltage reading in that screenshot always stays at 1.280. I must be doing something...

@aaron_atx Thanks for help. I have been reading other guides and using it as a reference to OC my setup. Now, I have ran into a wall. I can't seem to change the cpu voltage. I've tried to set it in manual and offset mode, but I see the same reading of 1.3761 under load. The only time it...

My stable test run so far is at 43 with cpu manual voltage at 1.305. My result after a 20min test run using Aida64. Temp: 68-73 cpu voltage: 1.3761 I am using realtemp to monitor the conditions. Is it normal for the cpu voltage to spike up over my set voltage? When I try 44, I get BSOD. How...

Thanks guys. I will try the baby steps on all 4 cores when I get the chance. I will report back with results. Anymore tips would be appreciated. My main reason to OC my pc is that currently, I am not satisfy with how long Photoshop is saving psd and, tiff files. On average, it takes about 40...

This will be my first OC experience. Can you provide a low setting for me to start from my initial settings of core1 - 48 core2 - 47 core3 - 46 core4 - 45 vcore = 1.360

I followed the guide and input what it said. I have no way of knowing the cpu temps since I cannot boot into Windows from a cold start. I do have a cooling system. It's a Corsair H60.

I have had this cpu for about 2 years and I want to boost some power out of it now. I've found this guide with the same cpu but a different model Asus board. After applying the settings as suggested, I am not able to boot to Windows. It freezes at the Windows Logo. What could be the issue...

Hello. I know this is an old post, but I can't find any answer that is close to what I have as far as hardware. I wanted to OC my setup but am having issue. The pc boots up to the Windows logo and hangs. It my settings because if I revert back, windows loads find. Here is my hardware. What would...