![[H]ard|Forum](/styles/hardforum/xenforo/logo_dark.png){kind=logo}
-
Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.
Recent content by dgalt
-
D
Color Matching 3 Qnix Qx2710 Monitors
So i'm not sure if this is what you're referring to, but in DispcalGui if I open up the Profile Information for the ICC profile generated for Monitor 1 when I set the whitepoint target as 6500K there are three lines at the bottom that say: GAMUT_volume: 1.19355207346 GAMUT_coverage (srgb)... -
D
Color Matching 3 Qnix Qx2710 Monitors
So the i1 Profiler software has the option of setting the white point measured from another monitor as the target white point for one's calibration (didn't know this before). Using this, monitors 1 and 3 are pretty darn close (judging by eye). Monitor 2, though, is still pretty different than 1... -
D
Color Matching 3 Qnix Qx2710 Monitors
Changing the Whitepoint setting from "As measured" to 6500K and re-running calibration resulted in a profile for Monitor 1 that seems closer to what we're shooting for. Delta E values for gray scale: 0.3 0.7 0.7 0.4 0.6 0.9 0.9 0.7 1.1 0.5 I ran calibration / profiling again on... -
D
Color Matching 3 Qnix Qx2710 Monitors
So, right now I only have 1 monitor (monitor 1) hooked up. Cleared out all profiles, re-ran DispcalGui calibration / profile generation, still getting same values as I was getting before for grayscale tracking. The settings I'm using in DispcalGui are as follows: Whitepoint: As measured... -
D
Color Matching 3 Qnix Qx2710 Monitors
That I do not know, there doesn't seem to be any information out there on it either. The only thing I could find is about the radeon 280x, which according to this post says it only supports a single LUT http://forums.amd.com/game/messageview.cfm?catid=440&threadid=184749 But older threads... -
D
Color Matching 3 Qnix Qx2710 Monitors
Retesting for monitor 1 gives me essentially the same gray scale tracking values, so not a mistake I assume. It seems the same is true for my third monitor (values below). Any suggestions on what to fiddle when generating the profile? Any other measurements I should take? Monitor 3 Red... -
D
Color Matching 3 Qnix Qx2710 Monitors
spacediver, thanks for the suggestions. I used HCFR as suggested, but the output doesn't exactly clarify anything for me (not entirely sure I'm using it properly). Below is what I think you're referring to, for two of the monitors (the two that are the most dissimilar). What should I be looking... -
D
Color Matching 3 Qnix Qx2710 Monitors
I have three QNIX QX2710 monitors that are setup side by side (using 2x R9 290X GPUs in crossfire). Each of these monitors has a noticeably different color profile - one has a bit too much red, one too much green, the third too much blue - especially against white / gray backgrounds (which...