Recent content by CRT_LoverBoy

I have a GDM-FW900 that I normally run at 2048x1280 and I'm looking for a second monitor that I can run dual displays on. There is enough space on my desk for a CRT but, I can't fit another 24" FW900. Maybe something like a 17 inch or so. What I "think I want" is an LCD I can run vertically...

PC: Hackintosh: Both on same GDM-FW900 display using Synergy as the KVM

Thanks for the tip about the plastic sheet. I'll keep that in mind.

I just got mine today and I must say it feels much better than the Bamboo I have. I will not be going back to my Bamboo. Based on my initial impressions I'd put the sensitivity around that of an Intuos3. The pen is my only real complaint, while I actually like the feel of it better than my...

Well look on the bright side. If you are a console gamer you can probably pick up a 34-36 inch Wega with SFP tubes for under $300 off craigslist. Spend about the same amount having it calibrated then apply the tweaks and watch your friends cry bitter tears that they spent over $2000 on their new...

Could be from age, I don't know. It's been documented before that Sony CRT's do this but, maybe it's just not as noticeable on this display vs a 34" TV.

I just ordered a Monoprice as well. The 10x6.25 has better specs than the Bamboo on paper. However, I don't think the Monoprice tablets use Magnetic Induction since the pens have batteries (I'm assuming no tilt response), they don't have an eraser or an assortment of nubs either but, that...

Not sure if this is the nature of the display or if it happens with anyone else. I have noticed that if you have the display on around 30 minutes to an hour then turn the display off for about 5 seconds and turn it back on again it will recalibrate itself and adjust the size and position to...