2k8 std w.hyper-v turning off whs guest after 2 hours

Status
Not open for further replies.

sabregen

Fully [H]
Joined
Jun 6, 2005
Messages
19,501
anyone know why my WHS VM on wk8 std w/hyper-v is being turned off after 2 hours? I've got the host and VM both set to High Performance/Always On Power Profiles in the Control Panel, and this is going to be a show stopper is I cannot figure out why it's doing this. Hopefully it's just something simple that I've overlooked.

Thanks!
 
my network performance is also ABYSMAL to the WHS VM. transfers from ANY host start fast, then basically drop to a creeping level (7.5MB/sec)... then about 2 minutes later, they spike again, and the process repeats. I've uninstalled Hyper-V Integration serves on the WHS VM, shut down, removed the virtual NIC, and saved the config... re-added the virtual NIC, booted the VM, installed integration services, rebooted, AND turned off TCP Offload on both the host and the VM... and there's been no change.
 
Dumb question but is the copy of WHS activated? I seem to remember that MS shuts down machines that aren't activated every 2 hours after a certan amount of time has passed.
 
my network performance is also ABYSMAL to the WHS VM. transfers from ANY host start fast, then basically drop to a creeping level (7.5MB/sec)... then about 2 minutes later, they spike again, and the process repeats. I've uninstalled Hyper-V Integration serves on the WHS VM, shut down, removed the virtual NIC, and saved the config... re-added the virtual NIC, booted the VM, installed integration services, rebooted, AND turned off TCP Offload on both the host and the VM... and there's been no change.

Sounds like the physical drives are transferring data slowly, ram frees up for caching after data finally spools out sufficiently, the cache fills back up to full, repeat. Pretty typical behavior for a 2k3 based box with disk write performance issues.

Same behavior on outgoing file copies?

How much RAM do you have allocated to your WHS?
What is perfmon showing for disk queue lengths and other performance counters during the transfers in WHS?
What is the performance reporting for the host reporting on its disk performance where the VHDs are hosted during these times?
 
Status
Not open for further replies.
Back
Top