Antec P183 and EATX Board

B

bern43

n00b
Joined
Aug 11, 2011
Messages
37
Anyone know if an Antec p183 case can fit an EATX board. Specifically thinking about the ASUS Maximus ROG z68 board. It looks like the extra inch might interfere with some of the cable routing? Anyone have any luck making these two work. I can take out the middle HD chamber if that helps.

Thanks!
 
I've got the P180 (original) and I think it has the same pin layout. I can measure my case if you want.
 
/\/\ Thanks. I've actually already got the P183. Was just wondering if anyone else has gotten this combo to work. It looks like it will just barely fit. If I remove the bottom HD cage it should work. I can route cables through there. Now I just need to double check if the ASUS Maximus uses the ATX pin layout. Anyone have any input on that?
 
You must log in or register to reply here.
Back
Top