WTB Dead Asus Z270E/F mobo for the plastic rear I/O cover or just the cover

scgt1

Supreme [H]ardness
Joined
Jun 4, 2007
Messages
5,470
I really have no interest in the board. All I want is the plastic I/O cover that goes over the rear connections. I have a Z270G Strix board that should have 3d printable parts but the designers for Asus are morons and incorrectly designed the cover for this area and made the lower screw mount internal of the cover instead of external therefore blocking the main PCI-E x16 lane up top from being used.

The cover for the 270 E and F series was designed to be externally mounted and have it hug the bottom of the Audio connector box leaving the space open for a top pci-e device. I'm aware this new design is held on with small screws and tabs. My intention is to cut the tabs off and mount the cover directly to the top of the rear I/O devices via double sided tape or velcro since my Z270G doesn't have the screw holes or tab holes for the new cover.

I'll attach a photo selecting what part I'm really after so no one gets confused with the I/O plate that goes in the back of a case.

Heat/Ebay is under scgt1.
 

Attachments

  • slideshow-3.jpg
    slideshow-3.jpg
    300.8 KB · Views: 0
Back
Top