"Use manual only" display option in CP?

C

contaminant

Limp Gawd
Joined
Nov 29, 2005
Messages
336
My screen flickers when I go to change settings. It used to do this with CCC and I am now using CP and the problem persist. However, with CCC there was an easy way to fix it you would go to the "display options" tab, select "use manual only." Then the problem would be fixed. I've looked through CP a few times now, but I can't find a similar option. Can someone tell me how to do it (assuming it's possible)?
 
NVM. As I had hoped, the problem disappeared with my old monitor (17' VGA 10x7 to 20.1" DVI 1680x1050 :D )
 
You must log in or register to reply here.
Back
Top