Thermalright SP-94 -- what fan to use?

J

jhtevans

Limp Gawd
Joined
Dec 14, 2002
Messages
374
I'm looking for some suggestions as to what fan to mate with the Thermalright SP-94.... I'm looking for good cooling without blowing out my eardrums - See sig for computer specs - I'd like to keep the noise below the intel stock sink ----
 
hmm...good performance..yet quiet enuf so that u can think>??
hmm...remember there is a trade-off between performance and noise when purchasing fans...there are fans all over the spectrum..

i personally think panaflow fans are the best for the noice to cfm ratio
get the panaflow 80mm Highs

or you could go all out and get tornados.....muhahaha
 
I use a 92mm Delta 110 cfm running at low speed on my fan controller. Nice and quiet at low speed and it keeps my 2.8 @ 3.07 at 37 C with a case temp of 30 C. Now of course if you were to run this fan at full speed you might think you had a hair dryer next to your head :D
 
I'm going to get a Panaflo H1A (92mm of course) with a fan controller to go on mine.
 
You must log in or register to reply here.
Back
Top