Hey everyone,
I am trying to write some scripts to change the zone transfer and notify servers for around 1000 internal zones but the Microsoft technet articles on these commands are lacking a lot on the syntax.
I was hoping that someone could point out how to do the spacing on the IP addresses in these commands so on each zone the zone transfer and notify servers are updated
Set-DnsServerPrimaryZone -Name mydomain.com Notify Notifyservers notifyservers 172.30.4.244 172.30.5.66 172.30.6.38 172.30.36.127 172.30.37.93 172.30.38.167" -SecondaryServers 172.30.4.244,172.30.5.66,172.30.6.38,172.30.36.127,172.30.37.93,172.30.38.167
I have tried spaces, spaces with commas, and commas directly with no results.
https://msdn.microsoft.com/en-us/library/jj649865.aspx
This is the article that I am referencing
I am trying to write some scripts to change the zone transfer and notify servers for around 1000 internal zones but the Microsoft technet articles on these commands are lacking a lot on the syntax.
I was hoping that someone could point out how to do the spacing on the IP addresses in these commands so on each zone the zone transfer and notify servers are updated
Set-DnsServerPrimaryZone -Name mydomain.com Notify Notifyservers notifyservers 172.30.4.244 172.30.5.66 172.30.6.38 172.30.36.127 172.30.37.93 172.30.38.167" -SecondaryServers 172.30.4.244,172.30.5.66,172.30.6.38,172.30.36.127,172.30.37.93,172.30.38.167
I have tried spaces, spaces with commas, and commas directly with no results.
https://msdn.microsoft.com/en-us/library/jj649865.aspx
This is the article that I am referencing