linksys wrt610n (how to make it work with ipv6...)?

[lukx]

I need to use ipv6 protocol but I can't make it work somehow...
I got Linksys wrt610N router and Linksys WUSB600N wifi card.
When I turn off TCP/IPv4 in network adapter settings it can not connect with Linksys router. Only when ipv4 is on it can connect. How I can make ipv6 work... pretty please help. I'm using some new software (3dsmax 2012 backburner (network rendering) and it only can use ipv6. So I'm totally stuck .

 

[C7J0yc3]

Your router isn't handing out IPv6 addresses. You would need to enable IPv6 support on the router, and set it a static IPv6 address, then you would need a DHCP server capable of handing out IPv6 addresses. I believe by default the DHCP server on the linksys firmware isn't capable of doing this, so you may need to setup a server somewhere else, or just statically assign your workstation an IPv6 address.

 

[Menelmarar]

Upgrade to DDWRT firmware, and enable ipv6?
No personal experience with that particular feature, but with other stuff DDWRT is top notch.

 

[gimp]

http://homecommunity.cisco.com/t5/Wireless-Routers/WRT610N-and-IPv6/td-p/249999
http://homecommunity.cisco.com/t5/Wireless-Routers/WRT610N-IPv6-support/td-p/378069

it's compatible with IPv6, but doesn't support it.

not that I completely understand what that means, but that's what is said between those 2 posts.

and also, just because...
http://intellidick.com/wordpress/2009/02/02/linksys-wrt610n-and-ipv6/

it does, or at least use to, apparently broadcast IPv6 but has no configuration settings available.