DVI to CRT monitor

S

spin02

Limp Gawd
Joined
Aug 13, 2004
Messages
196
I have a 40" Sony Wega (CRT) with DVI inputs. When I connect my X800XT-PE to it I get signal until windows starts to boot. Then I goes dead.

Any thoughts?
 
Try going into your display properties->displays tab->turning on TV display->click apply and see if it works that way.
 
If you have another monitor, try hooking it up to your second connector and switching the primary driver under desktop properties.
 
I will try all above suggestions. I have been able to get signal through component input, just not DVI.
 
I have a question relating to this, my monitor doesn't have DVI but my 9800 XT does. If I use a VGA spliter to DVI would this increase any performance/?
 
My PE has both VGA & DVI, honestly I can't see any difference. I am running an older monitor. I might be limited by that.
 
You must log in or register to reply here.
Back
Top