bluehorizon
Weaksauce
- Joined
- Jun 25, 2004
- Messages
- 100
From a post below, I gathered that I would need a hole saw with a diameter of 4.5 inches to cut a hole the right size for a 120mm fan; is this correct?
I looked on ebay; nothing I saw was 4.5". Aside from Home Depot or Lowes (which would be uber expensive I'm guessing), is there any place I can pick up one of these from?
Thanks!
I looked on ebay; nothing I saw was 4.5". Aside from Home Depot or Lowes (which would be uber expensive I'm guessing), is there any place I can pick up one of these from?
Thanks!