Hey everyone,
I have searched in regards to my current issue without any luck finding a resolution.
I recently purchased a Fractal Design Define R4.
After installing my components, I needed to hookup the cabling that comes from the front of the tower.
There were a total of 5 cables.
1) One larger wide blue connector with cable. This I attached to a PCI USB 3.0 card that I have.
1) One Molex 4-pin connector, which I connected to my PSU
3) Black 4(or 3) pin connectors that I have no idea where they go.
The Microphone/LED/Power button I have setup properly to the motherboard, but I cannot figure out where the bottom 3 connect to. I for some reason can't get my USB 3.0/2.0 ports to work at the front also.
Image for reference:
I have searched in regards to my current issue without any luck finding a resolution.
I recently purchased a Fractal Design Define R4.
After installing my components, I needed to hookup the cabling that comes from the front of the tower.
There were a total of 5 cables.
1) One larger wide blue connector with cable. This I attached to a PCI USB 3.0 card that I have.
1) One Molex 4-pin connector, which I connected to my PSU
3) Black 4(or 3) pin connectors that I have no idea where they go.
The Microphone/LED/Power button I have setup properly to the motherboard, but I cannot figure out where the bottom 3 connect to. I for some reason can't get my USB 3.0/2.0 ports to work at the front also.
Image for reference: