Hey,
after reset in OSD menu, resolutions are working great.
Left : WinDAS Right: my settings in CRU
HIGH setting:
MID setting:
LOW setting:
VESA 1600x1200 setting:
I am after geometry adjustments in HIGH mode and I must say that results are very promising, but I need to master my measure workflow. Parallax is killing my eyes.
Also after each turn on / turn off, this unit loses its previous settings, like if I set to 6500K then after restarting it would always go back to 9300K. Brightness and contrast always go back to 50/85. Not really big deal, but little annoying. Seems that someone has clicked MPU in this unit... Hope that going through entire procedure would keep it stable.
thank you spacediver for your kindness! Need to go to sleep for now, tomorrow is gonna be really interesting. I have been thinking about this polarizing foil for almost a year and finally I found glued one that seems to be really high quality and reasonably priced (around $35 per 35cm x 55 cm sheet).
after reset in OSD menu, resolutions are working great.
Left : WinDAS Right: my settings in CRU
HIGH setting:
MID setting:
LOW setting:
VESA 1600x1200 setting:
I am after geometry adjustments in HIGH mode and I must say that results are very promising, but I need to master my measure workflow. Parallax is killing my eyes.
Also after each turn on / turn off, this unit loses its previous settings, like if I set to 6500K then after restarting it would always go back to 9300K. Brightness and contrast always go back to 50/85. Not really big deal, but little annoying. Seems that someone has clicked MPU in this unit... Hope that going through entire procedure would keep it stable.
thank you spacediver for your kindness! Need to go to sleep for now, tomorrow is gonna be really interesting. I have been thinking about this polarizing foil for almost a year and finally I found glued one that seems to be really high quality and reasonably priced (around $35 per 35cm x 55 cm sheet).