Search results

Any reason in particular that you want to use a V351? To be honest if you're using a A05N its already a very small case. The V351 may even feel a bit bigger because of its cube size.

You should atleast PM a mod to let them know about this so no one else pays him unless everything clears up.

i need one!

sounds good!

Lol wow, that makes the V350 look so huge

That xigmatek will fit if you cut off about 1/3 of it. The PSU is also fine for your setup (Looking from the website it has 3 12V rails, which is more than enough for a midrange build)

Check to see how hot the mosfets are. The comp can be unstable if that area gets too hot. Try running a fan over those to see if it helps with the reboot

Actually those NB temps don't seem too bad with the stock heatsinks. If you're really worried you can always stick a 40mm fan on top of it.

See if you can still grab some Gelid fans, their 120mm fans are pretty nice while being dirt cheap.

Maybe you can take a look at the Lian li V350. IMO that case did a pretty good job in terms of placements except for the back. For that case, if you swap the PSU and HDD spots around, you can fit a 120mm exhaust right beside the CPU area PS, Tremeloes did a mod like that, maybe you can...

I'm using the same board and it does the same thing too. Tried with most of the settings but it still happens. If anyone knows an answer that would be great =)

if you're using the bottom slot you probably can fit a passive NB heatsink on there. any of the zalman ones are good. You can also get the thermalright hr-05, but its pretty expensive.

The fans they have in there might be slower speed fans? It says 1000rpm for the 120's.

Try turning them around anyways? All the fans i've seen have air come out from the label side of the fan

If you're going to use a mini ninja, it might block your first ram slots as your ram uses the tall heatsinks. I have the same setup but with an AMD 780G board and the minja blocked 2 of my ram slots. If the ram is normal height it'll fit under the side fins of the minja.

The DFI LP Jr P45-T2RS is the best choice for an mATX for overclocking. There's also a thread here about it right beside the V350 one =)

They don't seem to be available on their website and I already tried emailing them like 5 times with no response. As for the screws, it looks like it fits into the HDD holes but I havn't had a chance to try the CDrom holes.

Hey, does anyone know where to get replacement screws (the small ones) for the side panel? I lost some of them cuz they were so tiny =(