Search results

I have the same problem with a R9 Fury on a Supermicro X10SRH mobo. I'm convinced that the root of this problem is that when I reboot my Windows VM, the VM it is unable to release/reset the GPU. Thus when the Windows VM reboots and continues to load up again it tries to access a non-reset GPU...

To be honest, I'm not sure if that would work or not but it could be worth a shot. I simply discovered through many iterations (thank goodness for Restore Snapshot!) that running DDU before installing the AMD drivers was an important and necessary step to prevent the VM from locking up during...

Glad to hear you got it working. It sounds like it was much simpler for you, and in general other literature i've seen online seems to indicate that this is a little easier to get going with other GPU's from AMD. I decided to spend some time writing a step by step procedure to get this going...

A few days I posted that I had got the AMD R9 Fury working with GPU Passthrough in ESXi in this thread: Passthrough Gaming Rig Upgrade At the time i didn't quite know a step by step procedure of how I got things working (other than "i went to bed"), I just wanted people to know that it was...

No problem at all. Here's another thing you can try.. Boot into safe mode, and in Windows Device Manager, DISABLE your Radeon GPU (you know, right click, Disable) Reboot out of safe mode Get back into Windows... your Radeon GPU will still be disabled here of course, so your VM should boot up...

Haha. Very good, and valid, question. I have asked myself that question a few times, which is part of why i'm not quite yet prepared to try to rebuild from scratch yet, without enjoying things first. Part of the issue in my troubleshooting is that the displayport-connected monitor is a little...

Long time reader, first time poster. Just wanted to contribute after many years of reading, and more recently a lot of searching the 'net for experiences with GPU passthrough on ESXi 6.0 and an ATI R9 Fury. I couldn't find much out there, there's information on 280/290/380/390's but nothing on...