I rebooted, loaded Prime95, CPU-Z and RealTemp and ran it for 10 minutes:
I then stopped Prime95, ran Everest Ultimate, and again ran Prime95:
I suppose I could just disable EIST, but that seems to me treating the symptom, not the cause. :confused:
I've used both Prime95, OCCT and Performance Test 6.1 running for about 10 minutes. Once I run Everest, I've run Prime95 for an hour without errors. It starts running at 3.6 GHz right away.
I use CPU-Z 1.44.1 to measure the speed. Is there a more reliable way to measure?
I have a Gigabyte GA-EP35C-DS3R with an E8400 OC'd to 3.6GHz (FSB 400x9 at 1.275v.) At boot it's running about 2.4GHz with EIST enabled. But if I run Prime or OCCT even at full load it still runs at 2.4.
However, if I run Everest Ultimate it kicks up to 3.6GHz and from that point on will...
The power saving features are kicking in. Disable CIE and EIST at the Advanced Settings screen. Once settings are where you want then and the system is stable you can re-enable the power saving.
I too am new to overclocking, and I went through a lot of frustrations trying to get my system...
It's in the XPS600 docs. The Dell bios will support any Pentium D or Pentium 4 Extreme Edition up to 965. It won't support any Core 2 Duo processor.
You can check out the Dell Community Forums for more info.
Gigabyte has several boards with 8 sata ports. I have the GA-EP36C-DS3R, although I'm currently using only 4 of them (2 HD's, DVDRW, front panel esata)
Dave