"Please note that, currently, only the following products in ATIs Radeon X1900 Series and Radeon X1950 Series can run the application. We will post information about upcoming products that will support this application in the near future."
http://www.ati.com/buy/promotions/folding/index.html
I want to upgrade my heatsink with the XP-120 or the SI-120.
Question is does it fit our board A1 ? Do I need a backplate for both of them to mount it on our board. I know the SI-120 comes with a new K8 SM to mount the SI-120 on the board.
Any suggestions appreciated
its the Beta that was out a few months ago. Its now named E06
They modified the Idle Cycle Limit drop from 16 to 256. Cant remember if any other ajustement was made.Look with A64 tweaker and you will see before the update and after what exaclty changes were made.
eh im running my Dell 2405FPW with my single 7800GT and flawlessly. I do have to bring down a thin the details on some games. I dont really notice it though.
I currently own 2x 160gb IDE 7200 rpm, 2x 120GB SATA 7200RPM, 2x 20GB IDE 5400RPM Samsung drive and I never had a problem with them. Quiet, dont run hot at all compared to Maxtor crap. I already owned 3 hdisk Maxtor and all 3 burned out. So I never bought Maxtor again.
Boy, you want to freeze your processor with a ordinary fan ??
No fan nor watercooling system can freeze a processor.
Except 1 method. you to find out...
justy plug your 80GB on the first SATA port. Have your disk to install the drivers so WINXP can recognise your SATA drive and when prompt where to install your WINXP copy click on the first drive corresponding your 80GB and press ENTER. Format i and thats it. The install will do the rest.
the settings for your ram should be like this:
DRAM Cas Latency: 2
RAS Active Time: 5T
Ras Precharge Time: 2T
RAS to CAS Delay: 3T
DRAM Bank Interleaving: Enabled
DRAM Command Rate...
Im using 1GB OCZ Plat Rev.2 @ 2-2-2-5 2T 2.75v cuse unfortunetly 1T doesnt work good. I do run it at 1T for 2 weeks now and played Planetside and COD2 and never had a problem but it fails at Memtest.
Ive run this memory at 250mhz @ 3-4-3-7 default voltage 2.75v. Maybe when the new BIOS comes...
Just to let you know dont put your HTT at AUTO but set it at 800MHZ if you go over 250mhz FSB then lower it to 600mhz. It will be more stable like this.
Just to let you know you guys there will be a BIOS update on various tweaks, etc for the NF41 SLI this week.
Check here for info:
http://www.evga.com/community/messageboard/topic.asp?TOPIC_ID=11391𒇀
Hi everyone here's my CPU-Z screen shot. Ive been running stable at this clock for 2 days now. Does seem to be stable enough. No lock ups. Been Folding, using SuperPI and gaming for several ours without a problem.
CPU-Z Verified specs