Changed that now.. I could imagine problems, but private IPs are probably easy to find, why is it a security risk?
I'm tired of not reaching my other computers on LAN. Problem is that 192.168.0.xxx is used, then my router in garage uses 192.168.1.xxx and I also have a wifi at 192.168.10.xxx....
My soution so far: buying more switches and set up routers as AP. Then I can manage to keep most to same...
Reading electronics is difficult... There is a difference between 7620 ONV0 and 7620 ONVO and more... I read 7260 0NVO, I finally got somewhere with 72600 NVO and imho 72600 is more "the way" they do it. Google might not be the best on topics way off mainstream. Your other picture of card Has...
Yes, but PM needs some more posts on H to activate. I joined H in 2006, just did not contribute due to more easy to read forums available in Norwegian. I've always had a small crush on H, and since I got my invite here I'd share mine here. I was in your position some time ago ... do some...
Tec don't like users that sets the rules. BT is better now, but still. I need 4 or 5 devices connected at the same time, and it is a mess. Disconnecting, connects to wrong thingy, reconnect fail, plundering with audio menu (press 4 for BT, 5 for settings, 6 for quit this menu)...
The best comparison I've seen:
A couple of things to observe:
1. blobs dont leave bubbles
2. They didn't use big enough blob
3. There were no Ryzen cpu's there
Properly done blob/strip will be best.
I see nothing there :) Happy New Year ... It's 2021 over here :)
Edit: Copy paste from rules:
PMs have also been TURNED OFF for low post members to prevent scamming of our community members.
WARNING: Do not spam the forums to reach the required minimum, your posts will be deleted or your...
My card is 1.01 :-( Highest Memory volt is 2.1
The values you mention is not on my card.. i kept them in my doc for reference... They are marked with * ... I should have commented it I guess.
I run FSB at 420MHz now. Orthos (stess test) tells me there is an error, and it's brobably the...
Thanks a lot :-)
I'm now running 3080MHz with 440HMz FSB... I'd like to thighten the ram later.. :-)
Bios settings are much like yours:
PS: Printed on CPU: L629B162
AI Tuning: Manual
DRAM Frequency: 880
PCI-E Frequency: 100
PCI Clock Synchronization Mode: lock...
I can use FSB 320, but there is problems getting higher..
Basically I don't really know for sure what the settings in BIOS should be.
OC of Ram only should tell me what to expect from ram... The Kingston 2GB HyperX PC6000 should run at 750Mhz or FSB:RAM = 1:1 = 375MHz but that seems...
I've got the same "fail to verify EEPROM" message om my ASUS P5B-VM. Does this have any consequenses? I would like to verify the EEPROM before i shut down. Is there any experiences with shutdown/restart after this situation?