Search results

  1. J

    WTB: Mobo for sv24 or small form factor

    I need thissss. Only 15 years late...
  2. J

    replacement board for sv25, blown caps. need help ASAP

    This post would be great for me if I had a motherboard in mine at all... lol
  3. J

    P3 Tualatin RAM

    You wouldn't happen to have any of the SV24 parts or that adapter anymore, would you?
  4. J

    Hi there, I know this may be a stretch, but do you still have any FV24 or FV25 motherboards from...

    Hi there, I know this may be a stretch, but do you still have any FV24 or FV25 motherboards from Shuttle's Spacewalker PC from 2001? I saw that you mentioned you repaired and had some on this forum many moons ago.
  5. J

    SENTRY: Console-sized gaming PC case project

    Hello all, I vertically stand my Sentry, and regularly transport it to my girlfriend's house to play on LAN with her computer. One of my Sentry's rubber feet seems to have fallen off at some point. I didn't notice it until a couple of days ago, so it honestly could have happened at any time. I...
  6. J

    SENTRY: Console-sized gaming PC case project

    Update; System specs are the same as above still, no voltage changes to CPU. 9900K seems to run fine without throttling when slightly undervolted and TDP limited to 105W. Radeon VII was added. Barely fits, had to purchase low profile, 90 degree 8 pin cables to make it fit. Radeon VII is...
  7. J

    SENTRY: Console-sized gaming PC case project

    Update: 9900K is in the Sentry. TDP limited to 95W. Voltage offset -20mV AIDA64 stability test sees CPU hitting 100C, but no thermal throttling. System specs: -i9-9900K (Using LP53 with Noctua slim fan) -32GB G.Skill 3200Mhz -No GPU at this time (still deciding what to get) -Samsung 970 Pro...
  8. J

    SENTRY: Console-sized gaming PC case project

    You can. I’ve already checked on that, but I definitely want no less than a 1080 Ti. I think I’m going to wait for the CPU to actually get here, test on my LP53+Noctua and reassess from there, asking you guys for advice again. I’m going to make it work one way or another.
  9. J

    SENTRY: Console-sized gaming PC case project

    Yeah, I'm confident my LP53 and Noctua fan will be able to hold the line (For now...) and I will be disabling Multicore Enhancement if applicable on my board, as it technically runs outside of Intel's stock settings, and I will try to dial in the highest and most stable undervolt possible. I'm...
  10. J

    SENTRY: Console-sized gaming PC case project

    Thanks for the advice. I’ve done a little more research after reading the previous page on this thread, regarding the AXP-100. I found this cooler, it’s fully copper with a graphene coating. Without the fan on top, and underneath, it evidently satisfies the Sentry’s height requirement. What I’m...
  11. J

    SENTRY: Console-sized gaming PC case project

    I want to set up an 80MM radiator loop in the sentry, and I need advice. I’ve never done a custom loop before. I chose 80MM because I want the Zotac short 1080 Ti (the 211MM model) and a 92mm would be too close to the maximum 305MM length. The challenging CPU in question is the i9-9900K which...
Top