I assume the liquid is part of the lift system, Is there any way to drain this stuff out of it? I do not need the lift system as I use the chair on its lowest level.
If I were to drill into the canister, is this stuff under pressure?
Chair is a GTOmega Master XL that is 3 months out of warranty(I think it came with 3 year) Already contacted them about this but since its the weekend, it could take a while to hear back.
I did notice this morning that my chair was a little higher than I usually have it as it was a little difficult to move the chair with its armrests hitting the under side of my table, not by much though.
If I were to drill into the canister, is this stuff under pressure?
Chair is a GTOmega Master XL that is 3 months out of warranty(I think it came with 3 year) Already contacted them about this but since its the weekend, it could take a while to hear back.
I did notice this morning that my chair was a little higher than I usually have it as it was a little difficult to move the chair with its armrests hitting the under side of my table, not by much though.