Hello All,
After I awake my computer from sleep mode, I always get the screen shown in link below. The only thing I can do is reset the computer.
I've seen one other post about BSOD after awakening the computer from sleep mode for a Z170 board, but they were also mentioning a lot of overclocking tweaks.
Here is link to image of how monitors look after waking up.
http://i.imgur.com/3AnkA0x.jpg
Components as follows:
ASUS H170A PRO Gaming motherboard. Rev 1.03, BIOS 0507
CPU - i7-6700
OS --> Windows 10. Install fresh from 8 and follow upgrade path
32GB Memory ( 4 x 8GB Corsair Vengance DDR4 2133 )
No Graphics card. NEC runs off DVI port, Samsung off HDMI port on MOBO
PSU: SeaSonic 600HT
Diskdrives: 1 * Samsung SSD 256GB Pro, 2 * WD 250GB drives in RAID0 config( via Windows Storage spaces ).
MOBO settings are all stock settings apart from switching on HyperThreading so I can run android emulators using HAXM and Android SDK.
Systems has been very stable otherwise and no issues. It more of an annoyance at the moment as it means I cannot leave system in sleep mode if walking away from desk for a little while. But all the same, it's got me perplexed.
I saw one thread which said you must always awake the system using the power switch and not the keyboard. I have tried that as well - did not make a difference.
I have raised the issue with ASUS support as well but I was hoping somebody on these boards may have an inkling of where the issue lies.
with thanks.
After I awake my computer from sleep mode, I always get the screen shown in link below. The only thing I can do is reset the computer.
I've seen one other post about BSOD after awakening the computer from sleep mode for a Z170 board, but they were also mentioning a lot of overclocking tweaks.
Here is link to image of how monitors look after waking up.
http://i.imgur.com/3AnkA0x.jpg
Components as follows:
ASUS H170A PRO Gaming motherboard. Rev 1.03, BIOS 0507
CPU - i7-6700
OS --> Windows 10. Install fresh from 8 and follow upgrade path
32GB Memory ( 4 x 8GB Corsair Vengance DDR4 2133 )
No Graphics card. NEC runs off DVI port, Samsung off HDMI port on MOBO
PSU: SeaSonic 600HT
Diskdrives: 1 * Samsung SSD 256GB Pro, 2 * WD 250GB drives in RAID0 config( via Windows Storage spaces ).
MOBO settings are all stock settings apart from switching on HyperThreading so I can run android emulators using HAXM and Android SDK.
Systems has been very stable otherwise and no issues. It more of an annoyance at the moment as it means I cannot leave system in sleep mode if walking away from desk for a little while. But all the same, it's got me perplexed.
I saw one thread which said you must always awake the system using the power switch and not the keyboard. I have tried that as well - did not make a difference.
I have raised the issue with ASUS support as well but I was hoping somebody on these boards may have an inkling of where the issue lies.
with thanks.