MysticRyuujin
Limp Gawd
- Joined
- Oct 1, 2013
- Messages
- 507
So I have a Norco RPC-2214 case and RL-26 Rails and it works pretty well. The rails are TIGHT and difficult to put in and pull out but it works well enough. Their support was awesome too because I had a stripped thread in a rail and they sent me a new rail end piece no questions asked.
So I wanted to build a decent 1U workstation and thought, I'll go Norco again. I got the RPC-1204 with the same rails, as recommended on their website, but the darn thing doesn't fit because the top cover interferes with the rails! Also the motherboard port cover doesn't fit either, had to just go no-cover on the back. Sadness. I've had to rack it without a cover for now. I'm not the only one that's experienced this either. There's a review on Newegg that says the same thing. I've contacted their support about it and at first they were like "Did you install it right?" but I've sent them the below pictures...waiting for a response now. I don't think I've ever built a computer where every single part fit just perfectly the first time...but I only build something every few years.
So I wanted to build a decent 1U workstation and thought, I'll go Norco again. I got the RPC-1204 with the same rails, as recommended on their website, but the darn thing doesn't fit because the top cover interferes with the rails! Also the motherboard port cover doesn't fit either, had to just go no-cover on the back. Sadness. I've had to rack it without a cover for now. I'm not the only one that's experienced this either. There's a review on Newegg that says the same thing. I've contacted their support about it and at first they were like "Did you install it right?" but I've sent them the below pictures...waiting for a response now. I don't think I've ever built a computer where every single part fit just perfectly the first time...but I only build something every few years.