Recent content by sbao26975

Amazon has it going in and out of stock...might as well order. Cheaper than anywhere else. http://www.amazon.com/Silverstone-Aluminum-Mini-ITX-Certified-SG08B/dp/B006L6ZHEG/ref=sr_1_1?ie=UTF8&qid=1337719864&sr=8-1

It pretty much engulfs the entire thing. Makes routing cables a real pain in the ass.

Mount the top mounting plate as far in the other direction of the VRMs as possible. You still get a tiny bit of rubbing but it clears. And also when it's screwed down, the notches in the VRM heatsink fit nicely with the bridge. Also, there is a capacitor near the PCI Express that kind of gets...

Hopefully it's not that bad, everything is running fine.

Fixed it. Put slightly less pressure on it and insulated any possible metal on metal points. Weirdest problem I've ever encountered building a computer so far.

At 1.32V? Doesn't seem too likely. This is bizarre...I made another thread...it might just be the AXP-140.

So a few days ago I had the AXP-140 installed and working fine, but then I was stress testing it and it shut off. It would still turn on but it wouldn't boot. I took everything out of the case, and put the intel stock cooler on for easier access and it turns out it works. Today I replaced it...

So I was running at 4.5GHz at around 1.32V and Prime95 had been running for about an hour and then I get a shutoff. Everything turns on but I get no video and the computer doesn't boot. I tried the rear CMOS button, the jumper, and taking out the battery but still the same thing. Anyone know...

For those with an AXP-140 and fan, do you have it set up so that the fan is blowing up into the PSU or the PSU facing up and the fan facing down?

Honestly not a problem in an SG05. GPU doesn't move around at all.

There are two screws that you have to screw down. There's one that's near the I/O and one that's near the RAM. The one near the I/O is relatively easy to tighten but if you have taller RAM you have to install the RAM before you install the heatsink because there isn't enough space to install the...

Yes a GPU fits with a couple of mm to spare. Angle of picture makes it seem like it doesn't fit but it does. I'll take some better pics with my DSLR later, but here you go.

I'll take some more later when my low-profile sticks get in; this is the only one I have atm...not very useful sorry.

Ditto. Also using an AXP-140. It's a pain in the ass to mount if you don't have low profile RAM sticks though.

I cannot mount my AXP-140 well with my Ripjaws X since I have to install the Ripjaws X before the AXP-140. Takes a lot of effort and time. I went ahead and ordered a set of that samsung low profile so that I can put in RAM after mounting it. Right now I have it mounted, but temps are pretty bad...