Recent content by rudedog89

Just did the multi-meter and my -12v shows -10.95, The +12v is showing 12.21 . All 3.3 showing 3.39 , and 5 is showing 4.91.

It is 6 months old and it is an Antec NeoECO NE650M. The voltage has been showing that low out of package.

Ok. Ill get my voltmeter and check it, BUT lets say the multi meter shows the same results as the sensor, would this low voltage cause issues?

Here are the voltages in my sensors. The 12V seems awful low. Voltage Values: CPU Core 1.210 V CPU VID 0.825 V +3.3 V 3.248 V +5 V...

rmd3003, I have a ASUS ROG Strix B450-I Gaming and I am using the M2 slot above the PCIE slot where the video card is. There is a "heatsink", but the pad is really thick and I don't see how it can dissipate heat. The M2 ssd did not come with any heatsink on it. Maybe I should take off the...

Installed a MX500 M2 SATA and the temps kind of seem high to me. At system idle its around 47 but when I load it can get to 60 or little warmer. Is this bad? Am I within operating ranges?

Ded, I did look into that one as well, but, didn't notice any widgets with it. What I have been using and seems to work fine is, HWInfo64 with the windows gagdets . Seems to be working for me. Thanks for the suggestion

Fear, I don't know if I want to pay $70 for something, but, if it works, I might look into it. Question, do you have to use that module to use the software?

Ok thank you everyone. And sorry for the dick joke. Wasn't even thinking. =)

Well, it would be only an 8 inch extension, but, guess concerned about having the extra connector in the middle as I know that adds resistance as well.

Bueller

If I use an extension cable for my 24 Pin, there should be no voltage lost due to length, right? Sorry if this is a stupid question.

Currently, I am using the CAM NZXT software, and even though its ok, I would like something a little more configurable. On my old system, I was using Open Hardware. I loved it. The widget was configurable is why. Unfortunately it has not been updated for Ryzen, etc. Does anyone have a good...

Ok great. Glad Im not going nuts. Seemed to always do it when I wasn't paying attention, but, when I tried it and was paying it attention it didn't do it. Hopefully it will be a fix somewhere down the road. Thanks

This is in windows, the restart shutdown. Been doing it from the start. Just installed Windows 10 two days ago. After some testing it doesn't do it every time. It will restart normally or shutdown instead of restart about 50/50.