It does have 6 conductors and I was thing about try to use jumper wires but they are so close together and delicate that I would be concerned with shorting them. Truthfully it is not the fan I need but only the cable, it clips on to the fan under the sticker.
I had a stupid and horrible accident while doing the Igor's lab pad mod and severed the ribbon cable powering the lower fan. The one over the GPU (the two are slightly different). See picture below for what I am talking about.
Anyone that has water-cooled an FE card or knows where to get one...
FYI they only compute the electricity for the card not the whole system. You may want to add 50 to 100 watts to that depending what you have the card installed in
I'm starting to think they left out a whole bunch of costs in their calculator
Some I am trying to figure out and some that are clear
1.00% Pool
0.65% Miner software
Transfer Fees
- Slow (75 Gwei) 0.003975 ETH / $4.93
- Fast (131 Gwei) 0.006943 ETH / $8.61
Exchange Fees
Taxes
If anyone has...
Hahaha
You've been around here awhile. Don't you remember when overclocking and tweaking was using what you had instead of seeing how much you could spend?
I know it will not run at XMP but they should run somewhere below that. And I have them so might as while try to utilize them.
The 64GB is PC3200 CL 16 The 32GB is also PC3200 CL16. XMP profiles are very different for both but I felt if I went with the more relaxed timings it should work...
I am trying to combine a 64GB kit (2x32 Hynix M die) and a 32GB kit (2x16 Micron E die) on a Ryzen 3900x and X470 motherboard. I can get either kit to run independently or both kits if I drop frequency down to 2400MHz. I know I had read before there were specific timing to increase to allow 4...