Looking a single cable that will breakout power and ESATA from these new combo ports on modern laptops. Hoping for a DC pin+reg esata plug on one end, with a powered USB/eSATA on the other end.
It's for this
http://www.newegg.com/Product/Product.aspx?Item=N82E16817256031
Anyone ever come...
For me..it appears to be the DRAM voltage setting....I have the Gigabyte p67-UD4-B3, i tried to relax the voltage back down to 1.5v but the dreaded hang appeared again....i boosted it back up to 1.56V and it appears to be ok now.
[email protected]
RipJaw 4x4GB@1333
I think i may have found the cure for mine Gigabyte. I have XMP turned off right now....but there was a second option for memory settings, which I remember turning on to TURBO (middle option) when I put the new B3 board in. I went back and put it back to the lower or whatever is the "normal"...
I am also having similar problems with a Gigabyte UD4 sandy bridge setup with Ripjaw memory. The odd thing was, before the recall my board was rock stable....i got the new b3 stepping....and now I am getting the random lockups...for me...it looks like it kills my entire USB system....because my...
I am running G.Skill ripjaw F3-12800CL9D-8GBRL 4x4GB sticks, and just started running into this problem. I was having no problems on my Gigabyte UD4 before the recall for the SATA plug...SATA was working fine with 6 drives BTW....anyways...I get this new BM3 steeping UD4 motherboard...and it...
Got the new P67A-UD4-B3 Sandy Bridge replacement in the mail today from Newegg....dropped right in and rebooted...a few new driver installs from Win7 (Ethernet driver needed reloading) and it was back up and running. One thing to note, is that the BIOS version number is for B3 stepping...
Alrighty...thinking about dropping in another 8GB to give me a round 16GB of Ram...figure I allocate anwhere from 4-8GB for a ram drive to put my swap file....problem is it seems like Ram Drive software is hard to find....anyone have some good success stories??
SOooo....close...but screw holes on the wrong side for the given cutouts on my case...i need each port to be on it's own end...
http://www.lotes.cc/product_info.php?id=3377#
Getting there...but's only a single socket...