I am just trying to make things a little easier and not have to level the bed all of the time. Plus as I stated above I got it for free and thought it would be a good upgrade to the normal manual bed
Well, to tell you the truth I thought about doing this upgrade right after I got the printer but decided to wait. Had I not got the 3D Touch for free the other day I would not be thinking about installing it at all right now.
Ok so I have decided to install a 3D touch ABL on my Ender 3 Pro. I have never been very good at working on electronics and had a few questions as the included instructions are not very good.
Do I have to upgrade from the original control board to either the SKR Mini E3 V2.0 Control Board or...
Just an update, I originally was going to place my printer in the garage, however after being told that was not a good idea I did some rearranging and found a home for it right beside my desk. The great thing about this is that it allows me to start a print at the beginning of the work day and...
Awesome info, so if you could only buy one brand of PLA which one would it be?
Speaking of filament and storage where do yall keep your printers, I was actually thinking about locating my printer in the garage but there is alot of humidity here in Florida and my garage is not climate controlled.
Thanks I didn't realize until after I posted it that those were small spools
I am actually going to order one of these rolls (Recommended printing temperature at 190-210)
Ok Great, I was lookin gat some PLA as I think that is what I will tend to use more of. I see that there are different printer temperature ranges. I was reading that the ender 3 hot end can easily heat up to 280C but because of the it is not an all-metal hot-end, so the temperature is limited...