I'm a little confused how this case is 327mm tall but can support a top 45mm thick rad with 25mm thick fans. That's 70mm above the motherboard, and even excluding any clearances or the sheet metal thickness, the height of just that plus a mATX board w/5 slots is 2mm taller than the case:
I could see it maybe working if the top rad/fans are allowed to overlap the motherboard, but with the case being only 165mm wide they're going to be impinging on the motherboard's keepout zone. That might work fine with some boards, but I'd be careful about claiming compatibility for thicker rads if that's the case.
I could see it maybe working if the top rad/fans are allowed to overlap the motherboard, but with the case being only 165mm wide they're going to be impinging on the motherboard's keepout zone. That might work fine with some boards, but I'd be careful about claiming compatibility for thicker rads if that's the case.
It looks to me like a bottom rad is going to take the place of the PCI slots. One slot is ~20mm, so a 30mm rad + 25mm fans would take up the bottom three slots.So, is that WITH or WITHOUT having all of the PCI slots utilized…?